ipSentry monitors entries in sequential order (alphabetically and grouped). At the end of each cycle, there is a delay that allows ipSentry to remain idle, perform cleanup processing, and other tasks that might interfere with the monitoring process if these tasks were performed in the background. You may wish to adjust this delay based on the frequency at which ipSentry should monitor the devices.

1. From the ipSentry active display console, select Action, System Options. 
    
2. On the General tab you will need to modify the Pause Between Cycles field value.
    
3. This value can be defined as Minutes or Seconds. 
    
4. Press OK to save the changes.